Use of Rails to Locate R/W

Post Reply
Warren Smith
Posts: 1006
Joined: Thu Apr 13, 2006 6:41 am
Location: Sonora

Use of Rails to Locate R/W

Post by Warren Smith »

Does anyone recall an article in one of the national mags speaking about the preservation of rails to establish right-of-way? I think it was in the range of five years ago, could have been more; senior moment ...
Warren D. Smith, LS 4842
County Surveyor Emeritus
User avatar
pls7809
Posts: 1035
Joined: Tue Apr 13, 2004 3:48 pm
Location: Chino, CA

Re: Use of Rails to Locate R/W

Post by pls7809 »

Hi Warren,

Not sure about the magazine article, but the RR Surveying 101 seminar put on by Charlie Tucker had some great info about this. His recommendation was basically to not use the rails, if at all possible. When maintenance is done on the tracks, especially in curved portions, the tracks will be lifted and reset resulting in the tracks moving horizontally by anywhere from a few inches to a foot or two.

Ryan.
Warren Smith
Posts: 1006
Joined: Thu Apr 13, 2006 6:41 am
Location: Sonora

Re: Use of Rails to Locate R/W

Post by Warren Smith »

This had more to do with tangent sections, and using culvert structures where possible. It referenced rail-to-trails legislation, and conserving evidence.of alignment. Sadly, I cannot remember the author.
Warren D. Smith, LS 4842
County Surveyor Emeritus
User avatar
albanese
Posts: 7
Joined: Tue Mar 11, 2014 8:59 am
Location: Fresno, CA

Re: Use of Rails to Locate R/W

Post by albanese »

Warren,

Is this the article you are thinking of?

http://www.amerisurv.com/PDF/TheAmerica ... ne2008.pdf

-Eric
Warren Smith
Posts: 1006
Joined: Thu Apr 13, 2006 6:41 am
Location: Sonora

Re: Use of Rails to Locate R/W

Post by Warren Smith »

Why, yes it is. Thanks!
Warren D. Smith, LS 4842
County Surveyor Emeritus
Post Reply